Dataman 40Pro Manuel d'utilisateur télécharger pdf (Page 93)

PG4UW

Device can be select by double click on a line from list with desired manufacturer name and

device number or by entering device number in a search box (use a key <Space> as a

separation character) and press <Enter> or click OK button.

Press a key <Esc> or click Cancel button at any time to cancel device selection without

affecting the currently selected device.

Selected device is automatically saved to buffer of default devices. This buffer is accessible

with Device / Select from default devices command.

If you wish display additional information about the current device, use button Device info or

an <Ctrl+F1> key. This command provides a size of device, organization, programming

algorithm and a list of programmers (including auxiliary modules) that supported this device.

You can find here package information and other general information about current device

too.

Device / Select EPROM /Flash by ID

Use this command for autoselect an EPROM or Flash as active device by reading the device

ID. The programmer can automatically identify certain devices by the reading the

manufacturer and the device-ID that are burnt into the chip. This only applies to EPROM or

Flash that supports this feature. If the device does not support a chip ID and manufacturer's

ID, a message will be displayed indicating this as an unknown or not supported device.

If more devices with identical chip ID and manufacturer's ID were detected, the list of these

devices will be displayed. A corresponding device can be chosen from this list by selecting its

number (or manufacturer name) from list and press <Enter> (or click OK button). Press a key

<Esc> or click Cancel button at any time to cancel device selection without affecting the

currently selected device.

Warning: The control program only support this time EPROM’s and Flash with 28 and 32

pins. Any of programmers determines pins number automatically. For other programmers you

must enter this number manually.

The programmer applies a high voltage to the appropriate pins on the socket. This is

necessary to enable the system to read the device ID. Do not insert into the socket a device

that is not an EPROM or Flash. It may be damaged when the programmer applies the high

voltage.

We don't recommend apply this command to:

1) 2764 and 27128 EPROM types, because most of them ID not supports

2) Flash memories with non-standard pinout (e.g. Firmware Hub Flash)

3) Flash memories, which don't accept Vid voltage at A9 pin

4) low voltage EPROM and Flash memories

Device / Device options

All settings of this menu are used for programming process, serialization and associated file

control.

Device / Device options / Operation options

All settings of this command are used for programming process control. This is a flexible

environment, which content items associated with current device and programmer type.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 173 174

Pas de commentaire

Dataman 40Pro Manuel d'utilisateur Page 93